10Gbit/s Small Size LN Intensity Modulator (Package length:65mm)(Single Electrode Model)

Specifications

Model
 T.MZH1.5-10PD-ADC-S-Y-Z
(chirped)
 T.MXH1.5-10PD-ADC-S-Y-Z
(zero chirp)
Operating wavelength
 1.55µm
Insertion loss
 </=5.5dB
Drive voltage(Vπ) at 10Gbps
 </=5.0Vp-p
 </=5.5Vp-p
Optical bandwidth*1
 >/=10GHz
ON/OFF extinction ratio at DC
 >/=20dB
Polarization extinction ratio*2
 >/=20dB
Optical return loss
 >/=30dB
Chirp parameter alpha (typ)
 0.6 ~ 0.8
 -0.2 ~ 0.2
Maximum input power*3
 20mW
Input RF connector
 GPO connector
Optical fiber
 Input
 0.9mmΦ PMF
Output
 0.9mmΦ PMF or SMF
Fiber lead length
 Min0.7m(Input & Output)
Operating temperature
 -5~70ºC
Polarizer
 Output Side

PD Characteristics
 ---
Sensitivity
 0.04mA/mW ~ 0.40mA/mW
Extinction ratio
 >/=10dB
*1: 3dB down (1GHz reference)
*2: Only available for PMF output
*3: Input polarization must be aligned to the slow axis of polarization maintaining fiber.

Ordering Information                             Package size(Hermetically-sealed)



*1: When Other O is selected in the above ordering code, please specify your requirements with as much detail as possible.
*2: The Polarization state of input and/or output PMF is slow axis aligned.


Typical Data

1, Optical Bandwidth of 10Gbps Small Size LN Intensity Modulator

2, Electrical Characteristics of 10Gbps Small Size LN Intensity Modulator

3, Eye Pattern of 10Gbps Small Size LN Intensity Modulatolr


Recommended configuration

* This recommended configuration is only for giving general ideas. Please refer to the operation manual which is included with the product when you use the product. The operation manual shows you the appropriate way to use with any note.

(1) For proper adjustment, make optical connection prior to electrical connection otherwise the product may get damage.
The optical connection between the product and a power meter, or between the product and a laser source should be made when laser source is off.

 Any risk of making connection while laser source is working, such as loss of eyesight, should be at the user.

(2)
 The input fiber of the modulator must be optically adjusted with an optical laser source.
The schematic diagram is illustrated below.
(3)
 The output fiber of the modulator must be optically adjusted with a power meter.
The schematic diagram is illustrated below.
(4)
 You can work the laser source.
(5)
 Adjust the input side connector appropriately so that the input light power to the module is maximized.
The internal polarizer will get damage by improper adjustment and cause unexpected optical loss.
(6)
 DC Supply is connected to Auto Bias Circuit. Auto Bias Circuit and Driver are appropriately connected to modulator electrical inputs. The schematic diagram is illustrated below.
PIN or GPO connector should be fixed otherwise you will find low optical performance.


*DC Block capacitor should be inserted between driver and modulator RF port.
*This product is internally terminated, thus you do not need terminator.


Data Sheet